Section 6.6. 6 of the 2016 NFPA 13R does require attics that are used for living space, storage or that have fuel-fired equipment to have sprinklers. However, both the code (IFC/ IBC in Figure 1) and standard (NFPA 13R) will not require complete attic sprinkler protection for fuel-fired equipment.
Do I need sprinklers in attic?
The first interpretation stated that attics cannot be considered concealed spaces and therefore always require sprinklers.
When can you use NFPA 13R?
NFPA 13R requires sprinklers in occupied spaces like dwelling units, hallways, and common spaces. It allows places in residential buildings where fatal fires less-commonly start to go without sprinklers, like combustible concealed spaces, small bathrooms, and small closets.
What is difference between NFPA 13 and NFPA 13R?
While NFPA 13 is applicable to a variety of commercial buildings—both residential and nonresidential—NFPA 13R is essentially only applicable to low-risk residential structures that consist of four stories or less.
Does NFPA 13R require FDC?
A fire department connection (FDC) is required for most NFPA 13 and 13R automatic sprinkler systems and standpipe systems. They are not required for automatic sprinkler systems protecting one- and two-family dwellings and townhomes.
Are sprinklers required in ceiling voids?
Each sprinkler head is fitted accurately to ensure the sprinkler cover plate sits flush to the finished ceiling. A minimum ceiling void of 150mm is required when concealed sprinkler heads are installed.
What are attic sprinklers?
Reliable Attic Sprinklers provide protection of combustible and non-combustible light hazard concealed spaces with roof slopes of 4:12 to 8:12. Validated by actual fire testing, the Reliable Attic Sprinkler system features: Industry-leading coverage areas. Fewer branch lines and sprinklers required.
What NFPA code is for fire sprinkler?
NFPA® 13, Standard for the Installation of Sprinkler Systems, provides the minimum requirements for the design and installation of automatic fire sprinkler systems and exposure protection sprinkler systems.
Are sprinklers required in skylights?
NFPA 13, 2016 Section 8.5. 7 (Skylights) permits sprinklers to be omitted from skylights not exceeding 32ft² that are separated by at least 10ft horizontally from any other unprotected skylight or unprotected ceiling pocket. … (5) The unprotected ceiling pocket has noncombustible or limited-combustible finishes.
Do walk in type freezers coolers vaults and safes require sprinklers?
Do walk-in type freezers, coolers, vaults and safes require sprinklers? Yes. As explained by Formal Interpretation 78-6, these areas require sprinklers because they are part of the premises. … There are no exceptions provided which allow for Page 2 NFPA 13-1999 – FAQs sprinkler omission in these areas.
Do closets require sprinklers?
Sprinklers shall not be required in clothes closets, linen closets, and pantries that meet all of the following conditions: (1) The area of the space does not exceed 24 square feet. (2) The walls and ceilings are surfaced with noncombustible or limited-combustible materials.
What is a 13D sprinkler system?
NFPA 13D is a residential sprinkler design standard focused on one- and two- family dwellings and manufactured homes. The intent is to provide an affordable sprinkler system in homes while maintaining a high level of life safety.
What is a 13R sprinkler system?
NFPA 13R is a residential sprinkler design standard focused on low-rise residential occupancies. The Standard’s intent is to provide a sprinkler system that aids in the control of residential fires and provides improved protection against injury and life loss in multi-family dwellings.
Where should the FDC be located in relation to the sprinkler control valve?
3.1 says that the FDC shall be on the system side of the water supply check valve. This provision refers to the inlet, piping, check valve, etc. as being one unit. The sizing of all these components from the connection to the sprinkler system to the inlet shall be determined by 13(99) 5-15.2.
How many FDCs are required?
A typical standpipe system in a fully sprinkler protected facility may need up to four (4) FDC inlets to satisfy the system demand.
What pressure do you pump through a FDC?
All pumpers will pump their capacity at 150 psi at the pump, so increase the throttle slowly until your discharge pressure is at 150 psi while being careful not to run away from your water supply. If your pumper is equipped with a multi stage pump, place the pump in the volume stage.